|
Post by oldcarrestorer72 on Sept 1, 2010 17:27:44 GMT -6
Hey guys I have found a way to replicate seat belts using clay and Testors tube glue!! First squeeze the clay around until it is a little soft. Then take your seat belts (loose ones not the molded on the seat ones) and place them on the clay leaving an indentation on the clay!! This will be the mold!! Dont make it too deep. If you did it right you will have a nice mold of the seat belts!! Next pour in some Testors tube glue slowly so you wont get any bubbles!! Let it dry about a day or two!! Refill if necessary. When dry squeeze the clay from the bottom and the part should come loose!! Pull off with a hobby blade and trim and paint!! This is only for that necessary part that we sometimes do not have!! I have made hubcaps ,valve covers, dragster cowls ,radios, tool boxes and lots more stuff!! This is great for dioramas and junk stuff for dioramas!! Try it!!
|
|
|
Post by AL on Sept 1, 2010 21:20:33 GMT -6
thats a good idea.
|
|
|
Post by RodBurNeR on Sept 2, 2010 8:29:23 GMT -6
This sounds like a good idea and could be very handy. I only wonder how to glue....glue to plastic?
|
|
|
Post by oldcarrestorer72 on Sept 2, 2010 9:51:34 GMT -6
Glue?? Might work!!! Ha-Ha!! Try it ,youll like it!!
|
|
|
Post by AL on Sept 2, 2010 14:06:00 GMT -6
.... haha VERY good point Bob !!!
|
|