|
Post by flounder on Nov 28, 2007 0:45:15 GMT -6
Please help!!!!!!!!!!!!!!
I have finally gotten back to my Uncertain C project. I finished the distributor thanks to some great pics posted by Rob and Joe.
After staring at the pics posted on Honest Charlie's AWSOME site I figured out that the fuel pump is driven from the distributor shaft. Using the pics and an original kit distributor/fuel pump combo I was able to replicate the whole unit in aluminum.
The problem is I can not see all the fuel pump plumbing. I can see the steel braided line that goes from the gas tank and "Ts" into the fuel pump on it's way to the top of the injector distribution block. But I know that this can not be the only line.
So I am hoping one of you Klowns can post a clear drawing of how the fuel pump is plumbed. And how it routes to the rest of the fuel system. I have already mangnfied a couple pics from Charlie's site, but they lack enough detail.
I'll post pics of the finished unit. It's ridiculous how much work I have into this one part. Probably 30 pieces and counting.
Thanks in advance.
Flounder.
|
|
|
Post by Paul B. Canney on Nov 28, 2007 8:16:01 GMT -6
|
|
|
Post by flounder on Nov 28, 2007 14:32:31 GMT -6
Thank Paul!
I was about to let you know that I checked your site earlier and saw your pics, but then thought to look again. Thanks to your higher res scanning, I was able to blow up the pics and see what line goes where.
It looks as if the line from the gas tank runs into the pump is on on the front side. The line from the pump into the fuel block is on the back and it also Ts off as the overflow line that feeds back to gas tank. You can see the overflow line on the passenger side firewall.
It also showed me that my pump is pretty accurate. I think I'll leave my finish shiny since I went to all the trouble to make it from aluminum.
I'll be entering a distributor in the Open Showrod contest. LOL
Flounder
|
|
|
Post by Paul B. Canney on Nov 28, 2007 18:45:44 GMT -6
................ I'll be entering a distributor in the Open Showrod contest. LOL Flounder WHEW! I'm entering a cut decal sheet!
|
|
|
Post by robriley on Nov 28, 2007 18:48:08 GMT -6
................ I'll be entering a distributor in the Open Showrod contest. LOL Flounder WHEW! I'm entering a cut decal sheet! i'll be entering a bad medicine, unbuilt...but the box is open. hey, it is an open showrod contest right
|
|
|
Post by Paul B. Canney on Nov 28, 2007 19:59:18 GMT -6
WHEW! I'm entering a cut decal sheet! i'll be entering a bad medicine, unbuilt...but the box is open. hey, it is an open showrod contest right now THATS funny!
|
|
|
Post by Tim Nolan on Nov 28, 2007 21:39:02 GMT -6
Scott, your an anal whack-job............LOL! Good Lord-30 parts??!!!! YIKES.
|
|